Getting started
11
Battery installation and charging
Step 3
Charge the handset by placing it face
forward in the charger. The CHARGE light
on the top of the handset is on during
charging.
IMPORTANT INFORMATION
Use only the supplied rechargeable battery or replacement battery (model BT183342/
BT283342)
.
To order, visit our website at
www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
If you do not use the handset for a long time, disconnect and remove the battery to prevent
possible leakage.
Aer you install your telephone or power returns following
a power outage, the handset and base will prompt you
to set the date and time. For instructions on setting the
date and time using a cordless handset or the telephone
base, see Set date/time on page 20 and page 31,
respectively. To skip setting the date and time, press
OFF/CANCEL on a cordless handset or CANCEL on the
telephone base.
Step 2
Align the cover at against the battery compartment, then slide it upwards
until it clicks into place.
SET DATE
MM/DD/YY
SET TIME
HH:MM --
ÔTÉ VERS LE HAUT
:
2.4V 400mAh Ni-MH)
MENT :
URE BATTERIES.
CER LES PILES.
ine CR1349
To Next Page
Loading...
