THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine CR1349
Battery compartment cover
(1 for CL84115)
(2 for CL84215/CL84265)
(3 for CL84365)
Abridged
user’s manual
Abridged user’s manual
CL84115/CL84215/CL84265/
CL84365
DECT 6.0 corded/cordless
telephone/answering system
with caller ID/call waiting
Telephone base installation
This quick start guide provides you with basic instructions only.
For more complete instructions, refer to your Abridged user’s
manual provided in the package, or see the online Complete
user’s manual at www.telephones.att.com/manuals.
Quick start guide
CL84115/CL84215/CL84265/CL84365
Caution: Use only the power adapter provided with this product. To obtain a replacement, visit
our website at www.telephones.att.com or call 1 (800) 222-3111. In
Canada, dial 1 (866) 288-4268.
Charger installation
Raise the antenna.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back
of the telephone base.
Plug the large e nd of the
telephone base p ower
adapter into a po wer
outlet not control led by a
wall switch.
Plug one end of the
telephone line cord
into a telephone jack
or a DSL filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Telephone line cord
Route the cords through
the channels.
Plug the other end
of the coiled handset
cord into the jack
on the back of the
telephone base.
One end of the coiled
handset cord has already
been plugged into the
handset. Make sure it is
plugged in firmly.
Route the handset
cord through its
channel.
Plug the power adapter into
a power outlet not controlled
by a wall switch.
Telephone line cord
To Next Page
Loading...
