Answering system
88
About the answering system
To screen a call at the handset:
While a message is being recorded, the handset shows To screen call, press
[SELECT]. Press MENU/SELECT to screen the call.
Options while a message is being recorded:
Press qCID/VOLUME or pDIR/VOLUME on the handset to adjust the call
screening volume.
Press
OFF/CANCEL to temporarily silence the call screening.
Press MENU/SELECT to temporarily turn on the call screening if call
screening is set to off.
Press /SPEAKERSPEAKER to turn off the speakerphone and screen the call
through the handset earpiece.
Call intercept
While screening a call, you can stop recording and speak to the caller by
pressing
PHONE/FLASH on the cordless handset, pressing /SPEAKERSPEAKER on
the telephone base, or lifting the corded handset.
Base ringer
Press VOL
q or VOL
p on the telephone base to adjust the ringer volume
when the telephone is not in use.
You hear a sample of the ringer while adjusting the volume. The telephone
base shows Ringer off and when you set the volume to 0.
Temporarily turning off the message alert tone
If the message alert tone is turned on, the telephone base beeps every
10 seconds when there are new messages. Pressing any telephone base
key temporarily silences the message alert tone.
If you press X/DELETE when in idle mode to temporarily turn off the
message alert tone, there is a voice prompt directing you to press X/DELETE
again to delete all old messages. The message alert tone is temporarily off.
Only press X/DELETE a second time if you wish to erase all old messages in
your answering system.
The message alert tone resumes when you receive another message.
•
•
•
•
To Next Page
Loading...
