Multiple handset use
Push-to-talk (PTT)
Make an outgoing call during PTT call
Using a handset or the telephone base:
During a one-to-one PTT call, press HOME/FLASH on your handset or
telephone base to get a dial tone. The PTT call ends automatically.
During a one-to-group PTT call, press HOME/FLASH on the initiating
handset or telephone base. The PTT call ends automatically and you get a
dial tone.
During a one-to-group PTT call, press HOME/FLASH on any one of the
destination handsets or telephone base. That device gets a dial tone. The
PTT call continues for the rest of the PTT participants.
End or leave a PTT call
Using a handset or the telephone base:
For one-to-one PTT calls, both initiating and destination devices can end the
PTT call. For PTT calls to multiple devices, the initiating device can end the
PTT call. If any one of the destination devices leaves the PTT call, the call
continues until all participants or the initiator hangs up.
Press OFF/CANCEL or END on the handset, or press CANCEL or END on
the telephone base. The screen shows Push to talk Ended.
-OR-
Place the handset in the telephone base or charger, then the handset
return to idle mode.
NOTE: After PUSH TO TAL� on the handset or PTT on the telephone base is released, the PTT
call remains open for a short time. If no one presses PUSH TO TAL� on the handset or PTT
on the telephone base within ten seconds, the PTT call ends automatically.
•
•
•
80
To Next Page
Loading...
Need help?
General
