Answering system
Answering system settings
Using the telephone base:
1. When the telephone base is in idle mode, press MENU to
enter the main menu.
2. Press SELECT to select Answering sys.
3. Press qCALLER ID or pDIRECTORY to scroll to Ans sys
setup, then press SELECT.
4. Press qCALLER ID or pDIRECTORY to scroll to
#
of rings,
then press SELECT.
5. Press qCALLER ID or pDIRECTORY to choose among
2, 3, 4, 5, 6 or Toll saver.
6. Press SELECT to save the setting. You hear a confirmation tone.
NOTE: If you set the number of rings for the answering system as 2 or 3 rings, the caller
ID announce feature may not have enough time to announce the caller’s full information.
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
Using a cordless handset:
1. When the handset is in idle mode, press MENU to enter the
main menu.
2. Press qCID or pDIR to scroll to Answering sys, then
press SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then
press SELECT
4. Press qCID or pDIR to scroll to Remote code, then
press SELECT.
5. Use the dialing keys to enter a two-digit number. Press
MUTE/DELETE to backspace and delete a digit.
6. Press SAVE to save the setting. You hear a confirmation tone.
108
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
# OF RINGS
6
5
4
BACK SELECT
SELECT
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK
R EMO TE C ODE
19
SAVE
BACK
To Next Page
Loading...
Need help?
General
Weight and Dimensions
