AT&T E5828B - To Dial or Change an Entry

29
Telephone operation
1
DIR
2
DIR
3
DIR
DIR
To dial or change an entry
You can make existing directory entries to speed
dial entries if they are stored in the handset.
You can also change names, numbers and the
distinctive ringing settings, or erase entries, that
are stored in the cordless handset or the tele-
phone base. When any entry is displayed, press
SELECT/TRANSFER to see the options. Press CID
or DIR to highlight the option you want (blinking
text), then press SELECT/TRANSFER.
To make an entry a speed dial entry (cordless
handset only)
When SPEED is blinking, press SELECT/TRANSFER, then
dial a memory location (1-9) to make this entry a
speed dial entry.
If you choose a memory location that is already
assigned to a different entry in the directory, that
entry will remain in the directory, but will not have
a speed dial location.
To edit an entry
Press CID or DIR until EDIT is blinking, then
press SELECT/TRANSFER. You can change the name
and number (or distinct ring setting on the cordless
handset) by following the steps described on pages
26-27.
To delete an entry
Press CID or DIR until ERASE is blinking, then
press SELECT/TRANSFER to display a confirmation
screen ( ERASE NO YES ).
To delete the entry, press DIR to highlight YES ,
then press SELECT/TRANSFER.
To abort the procedure and leave the entry intact, press
CID to highlight NO, then press SELECT/TRANSFER.
Press SELECT/TRANSFER to
choose blinking option on the
handset.
NOTES:
1. Screens shown above are
displayed on the cordless
handset. The telephone
base display is slightly dif-
ferent, but the procedure is
the same.
2. See page 27 for instruc
-
tions on dialing a directory
entry from the base.
DIRECTORY
ADRM
5551234
SPEED EDIT ERASE
5551234
SPEED EDIT ERASE
5551234
SPEED EDIT ERASE
5551234
SELECT/TRANSFER