28
Telephone operation
Handset locator
You can use the handset locator feature to nd
misplaced handsets.
To start the paging tone:
Press /HANDSET LOCATOR on the telephone
base to start the paging tone on all handsets for
60 seconds.
To stop the paging tone:
Press PHONE/FLASH, /SPEAKER,
OFF/CANCEL or any dialing key (0-9, or #) on
the handset(s).
-OR-
Press /HANDSET LOCATOR on the
telephone base.
-OR-
Place the handset in the telephone base or charger.
NOTES:
If you press MUTE/DELETE on a handset, the ringer of that handset is silenced but the paging
tone continues on the other handsets.
If a handset is accessing the answering system, on a call (intercom call or outside call), or out
of range, that handset does not beep when paged.
You cannot use the handset locator feature while the telephone base is playing messages or
the answering system is being accessed remotely.
Web address
You can use the web address feature to view the AT&T
website address.
Press MENU/SELECT in idle mode.
Press CID or DIR to scroll to Web address, then
press MENU/SELECT. The screen shows the AT&T
Website address.
•
•
•
•
•
•
•
1.
2.
www.telephones.
ECO
att.com
ECO
To Next Page
Loading...
