1
Install the telephone base close to a telephone wall jack and an electrical
outlet not controlled by a wall switch. The telephone base can be placed on a
at surface or vertically mounted on the wall (page 13). For optimum range
and better reception, place the telephone base in a central and
open location.
If you subscribe to high-speed Internet service (DSL- digital subscriber
line) through your telephone line, you must install a DSL lter between
the telephone line cord and the telephone wall jack (page 7). The lter
prevents noise and caller ID problems caused by DSL interference. Please
contact your DSL service provider for more information about DSL lters.
Your product may be shipped with a protective sticker covering the handset
or telephone base display - remove it before use.
For customer service or product information, visit our website at
https://telephones.att.com or call 1 (800) 222-3111.In Canada, dial
1 (866) 288-4268.
Avoid placing the telephone base and charger too close to:
X Communication devices such as television sets, VCRs, or other
cordless telephones.
X Excessive heat sources.
X Noise sources such as a window with trac outside, motors, microwave
ovens, refrigerators, or uorescent lighting.
X Excessive dust sources such as a workshop or garage.
X Excessive moisture.
X Extremely low temperature.
X Mechanical vibration or shock such as on top of the washing machine or
work bench.
Getting started
Installation
STOP!
You must install and charge
the battery before using the
cordless handset.
See pages 8-10
for easy instructions.
To Next Page
Loading...
Need help?
General
