AT&T Osprey - FCC Compliance Statement

13
Version 1.0 11/2018
User Manual—Streaming Device and Remote Control
B. Federal Communications Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Responsible Party:
AT&T/DIRECTV
2230 E. Imperial Hwy
El Segundo, CA 90245
1-800-DIRECTV
• Trade Name: AT&T/DIRECTV
• Model Number: C71KW and RC81V
Federal Communications Commission (FCC): This equipment complies with both Part 15 and Part 68 of
the FCC Rules.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by removing and
applying power to the equipment, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Connect the equipment into an outlet on a circuit dierent from that to which the streaming device
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• CAUTION: Changes or modications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
The user may nd the following booklet, prepared by the Federal Communications Commission,
helpful: “How to Identify and Resolve Radio and TV Interference Problems.” This booklet is available
from the U.S. Government Printing Oce, Washington, DC. To meet FCC requirements, only peripherals
(computer input/output devices, terminals, printers, etc.) certied to comply with Class B limits may
be attached to this device. Operation with noncertied peripherals is likely to result in interference to
radio and TV reception. To meet FCC requirements, shielded cables are required to connect the device
to a personal computer, peripheral, or other Class B-certied device.