19
Getting started
After you have installed the AT&T Softphone Call Manager,
check to make sure the audio setting is properly configured
in your Windows system. If you have installed Skype and/or
Microsoft Lync and want to use them with your headset,
make sure the audio settings are configured correctly in the
programs as well.
a) Audio settings in Windows system:
Launch the AT&T Softphone Call Manager program.
Click on the Settings panel, then the General panel.
Click on [Click to launch audio devices control panel].
Make sure AT&T DECT Headset is selected under the
playback and recording settings in your Windows system.
b) Audio settings in Skype:
Launch the Skype program.
Click on Tools, then Options.
Click on Audio settings.
Make sure AT&T DECT Headset is selected under the
speakers and microphone settings.
c) Audio settings in Microsoft Lync:
Launch the Microsoft Lync program.
Click on Options, then Audio device.
Make sure AT&T DECT Headset is selected under the
Audio device setting.
14.
i.
ii.
iii.
iv.
i.
ii.
iii.
iv.
i.
ii.
iii.
Headset base and handset lifter installation
Option 2: Connect the headset to a corded phone and
computer (cont.)
IMPORTANT
Periodically check for software updates. Go to the Support panel in
the AT&T Softphone Call Manager, then click on Check now. For
more details, refer to the Installation and Operation Guide for AT&T
Softphone Call Manager.
To Next Page
Loading...
