AT&T TL86103 - Caller ID Announce

25
Caller ID
This product supports caller ID services oered by most telephone service
providers. The telephone stores caller ID information of the last 50 incoming calls in
the telephone base. This information is common to all devices.
Caller ID announce
When this feature is on and you have an incoming call, the handset and the telephone
base speaks “Call from...” and the name of the caller based on the directory or caller ID
information. The default setting of caller ID announce feature is On. You can turn this
feature o.
Using the telephone base:
1. Press MENU in idle mode to enter the main menu.
2. Press CID, DIR, /RECORD, or /DELETE to highlight Caller ID Annc, and
then press SELECT .
3. Press CID, DIR, /RECORD, or /DELETE to choose On or O, and then
press SELECT . You hear a conrmation tone and the screen shows
CID Annc ON/OFF on all HS & BS briey before returning to the previous menu.
Review and dial a number in the call log
Using a cordless handset or the telephone base:
1. Press qCID on the handset or the telephone base in idle mode -> Press q/p to
scroll through the list.
2. Press LINE 1/FLASH , LINE 2/FLASH, or /SPEAKER on the handset, or press
1 LINE or 2 LINE on the telephone base, or lift the corded handset to dial with line
1 or line 2.
-OR-
Press A CELL or B CELL on the handset, or press CELL A or
CELL B on the telephone base to dial with the cell line.
Erase missed calls indicator in the call log
Using a cordless handset or the telephone base:
When you have incoming calls that have not been answered, the handset screen
displays XX missed calls, and the telephone base screen displays XX. When you
have reviewed all the missed calls, the missed call indicator is erased.
If you want to erase the missed call indicator without reviewing the caller ID log,
press and hold OFF/CANCEL on a handset, or CANCEL on the telephone base.