AT&T TL86103 - Bluetooth Setup

27
Turn answering system on or o
The answering system must be turned on to answer and record messages.
Using the telephone base:
f Press /LINE 1 ANS ON/OFF or /LINE 2 ANS ON/OFF to turn the
corresponding answering system on or o. If the answering system is turned
on, it announces, “Calls will be answered.” If the answering system is turned o, it
announces, “Calls will not be answered.”
-OR-
1. When the telephone base is in idle mode, press MENU to enter the main menu.
2. Press SELECT to select Answering system.
3. Press CID, DIR, /RECORD, or /DELETE to highlight Mailbox 1 or Mailbox
2, and then press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to highlight Answer ON/OFF, and
then press SELECT .
5. Press CID, DIR, /RECORD, or /DELETE to highlight On or O, and then
press SELECT to save the setting. You hear a conrmation tone.
Message alert tone
When this feature is on, and there is at least one new message, the telephone base
beeps every 10 seconds.
Using the telephone base:
1. When the telephone base is in idle mode, press MENU to enter the main menu.
2. Press SELECT to select Answering system.
3. Press CID, DIR, /RECORD, or /DELETE to highlight Mailbox 1 or
Mailbox 2, and then press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to highlight Ans system setup,
and then press SELECT .
5. Press CID, DIR, /RECORD, or /DELETE to highlight Msg alert tone, and
then press SELECT .
6. Press CID, DIR, /RECORD, or /DELETE to choose On or O.
7. Press SELECT to save the setting. You hear a conrmation tone.
Answering system