5
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see table below). If necessary, place the handset in the telephone base or
charger to charge the battery. For best performance, keep the handset in
the telephone base or charger when not in use. The battery is fully charged
after 16 hours of continuous charging. See the table on the Technical
specifications page in the user’s manual for battery operating times.
If the screen shows Low battery, you need to charge the battery without
interruption for at least 30 minutes to give the handset enough charge to use
the telephone for a short time. The following table summarizes the battery
charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank or shows
Place in charger.
The battery has very little
or no charge. The handset
cannot be used.
Charge without interruption
until the screen shows
Low battery or HANDSET X
(at least 30 minutes).
The screen shows
Low battery and flashes.
Battery has enough charge to
be used for a short time.
Charge without interruption
until the screen shows
HANDSET X (at least 30
minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone
base or charger when not
in use.
NOTE: If you are on a call in low battery mode, you hear four short beeps every minute.
To Next Page
Loading...
