7
Bluetooth setup
Enter the PIN of the telephone base (the default PIN
is 0000) into your cell phone to continue the pairing
process.
When a device is successfully connected, the handset
displays Paired with cellular and then Cellular setup
completed Device connected. The corresponding status
icon ( 1 or 2) displays. The corresponding device light
on the telephone base (DEVICE1 or DEVICE2) turns on.
If you already have two devices on the active devices
list, the handset shows Maximum of 2 devices can
be connected. You are prompted to replace an
existing device on the active devices list (page 13).
NOTES:
The pairing process may take up to one minute. If the pairing process fails, try again.
If you put the handset back in the telephone base or charger while pairing, the process
discontinues and the handset returns to idle mode.
Auto connection
When a device is successfully paired with the telephone
base but not connected, the handset displays
Cellular setup completed Device not connected and then
Auto-connect function enabled Press SELECT. You can
press MENU/SELECT to exit. You can also connect a device
manually (page 12).
8.
9.
•
1.
2.
Base name:
AT&T DECT 6.0
CODE:0000
Cellular setup
completed
Device
connected
Cellular setup
completed
Device not
connected
Auto-connect
function
enabled
Press SELECT
To Next Page
Loading...
