72
Multiple handset
Push-to-talk (PTT)
Using the telephone base:
There are a few ways to begin a PTT call to a single handset. When the
telephone base is not in use:
If you have one handset, press and hold PTT in idle mode.
-OR-
If you have more than one handset, press PTT in idle mode. Use the
dialing keys to enter a handset number (1-9 for handsets 1-9, TONE
and 0 for handset 10, TONE and 1 for handset 11 or TONE
and 2 for handset 12), or press CID or DIR to scroll to the desired
handset then press SELECT or PTT to create the push-to-talk session.
Your handset displays Connecting to HANDSET X... (HANDSET
represents the handset name, X represents the destination handset
number) for a few seconds. When the connection is made, both the
telephone base and the destination handset display Press and hold
[PTT] to talk and beep once.
Press and hold PTT. A chirp indicates your microphone is on. Speak
towards the telephone base. Your voice is broadcast to the destination
handset. While you are speaking, the handset displays PTT To HANDSET
X (X represents the destination handset number).
Release
PTT
after speaking. Both devices beep once again and the screens
show Press and hold [PTT] to talk, then you can press and hold
PTT
to
continue speaking or the destination handsets can respond (see Answer a
PTT call on page 75).
To end the PTT call, press CANCEL or END. The telephone base shows
Push to talk Ended for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the PTT call.
The telephone base shows Push to talk Ended for a few seconds.
NOTE: After PTT is released, the PTT call remains open for a short time. If no one presses
PTT within 10 seconds, the PTT call ends automatically.
•
•
2.
3.
4.
5.
To Next Page
Loading...
