AT&T TL96423 - PTT to a Single Handset

71
Multiple handset
Push-to-talk (PTT)
PTT to a single handset
Using a cordless handset:
There are a few ways to begin a PTT call to a single device. When the
handset is not in use:
If you have one handset, press and hold PUSH TO TALK in idle mode.
-OR-
If you have more than one handset, press PUSH TO TALK in idle mode.
Use the dialing keys to enter a handset number (1-9 for handsets 1-9,
TONE and 0 for handset 10, TONE and 1 for handset 11 or
TONE and 2 for handset 12).
-OR-
Press CID or DIR to scroll to the desired device then press SELECT or
PUSH TO TALK to create the push-to-talk session.
The handset displays Connecting to HANDSET X... (HANDSET represents
the handset name, X represents the destination handset number) or
Connecting to BASE 0... (BASE represents the base name) for a few
seconds. When the connection is made, both your handset and the
destination device display Press and hold [PTT] to talk and beep once.
Press and hold PUSH TO TALK. A chirp indicates your microphone is on.
Speak towards the handset. Your voice is broadcast to the destination
device. While you are speaking, the handset displays PTT To HANDSET X
(X represents the destination handset number) or PTT To BASE 0.
Release PUSH TO TALK after speaking. Both devices beep once again and
the screens show Press and hold [PTT] to talk, then you can press and
hold PUSH TO TALK to continue speaking or the destination handsets can
respond (see Answer a PTT call on page 75).
To end the PTT call, press OFF/CANCEL or END. The handset shows
Push to talk Ended for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the PTT call. The
handset shows Push to talk Ended for a few seconds.
NOTE: After PUSH TO TALK is released, the PTT call remains open for a short time. If no one
presses PUSH TO TALK within 10 seconds, the PTT call ends automatically.
1.
•
•
2.
3.
4.