Atari CX2600

NOTE: Using any AC Power Supply other than that designed for your
Video Computer System can damage the unit.
POWER REQUIREMENT: 9·volts DC, 500ma.
• On
the TV/Game Switch Box that you have attached to your TV set 's
antenna terminals, push the TV/Game switch to GAME .
• Turn on your TV.
• Set
the volume control of your TV at minimum.
• If your TV has an automatic fine·tuning control, turn it OFF ,
and manually fine-tune for the best picture. (Note : If your
television will receive color only when the automatic fine-
tuning is on, keep the automatic fine-tuning on.)
• Set the channel selector of your TV to channel 3.
The Video Computer System is factory-set to operate on Channel
3. However , if Channel 3 is broadcast ing in your area, you may
receive
interference. In that case, change your television and
Channe l Switch to Channel 2.
To set your game at Channel 2
(Position A) :
1 -
Find the Channel Switch
on the bottom edge of the
console .
2 - Push the switch to the
Channel 2 po s ition (A)
with a pencil or
similar instrument.
INSERT GAME PROGRAM
• Check to see that the Power switch on the Video Computer Console
unit is OFF .
IMPORTANT: To prolong the life of your Atari Video Computer System
and protect the electronic components, the Console unit should be
OFF when inserting or removing a Game Program.