Atari MEGA STe

Coprocessor
Installation
Kit for
the
Atari® MEGA STE™
Kit
Contents
Your Atari Coprocessor kit P/N CA40
1092-001
should contain
the following items:
•
Coprocessor Chip Part Number: C 1 0 1 7 1
8-
1 01
•
PAL Chip Part Number: C301
903-001
•
Installation Manual Part Number: C30222
8-001
If any of these components are missing from your kit please
contact the outlet from which the kit was purchased.
Tools Required:
*
Phillips screwdriver
*
Flat blade (slotted)
screwdriver
Installation
The following steps should be completed in the following
order to install the Coprocessor in your Atari MEGA STe
computer. Carefully read each step all the way through before
taking any action required by that step.
WARNING
This installation should be performed in a static free
environment.
Static can cause damage to the coprocessor and
PAL chips. Failure to perform each step completely or
skipping steps could result in damage to the RAM Expansion
board or your computer.
1. Turn off your computer and disconnect all cables from
the sides and back of the unit (for example the keyboard,
power cord, external disk drive and so on.).
1