ATD AIR ATD-6901 User Manual

1
ATD-6901
1.4MM TOP COAT GUN W/CUP
INSTRUCTION MANUAL
Read this manual carefully and understand it completely.
Retain manual for future use.
Always follow safety precautions to prevent personal injury and/or damage
to the equipment.
Illustrations and photos are intended for reference only. Actual product may vary.
Specifications are subject to change without notice.
Important Safety Instructions
1. Always wear eye protection, gloves and respirator to prevent against harmful
vapors while spraying.
2. Never use oxygen or any other combustible or bottle gas as a propellant.
Explosion and serious injury or death may result.
3. Many paints and solvents can be highly flammable. Please use the spray gun
only in well-ventilated areas, do not smoke or use near open flame.
4. Always disconnect the paint gun from air supply when not in use and during
maintenance. For emergency stopping and to prevent unintended operation, a
valve near the gun is recommended.
5. Inspect the tool before each use to ensure there is no leakage or misaligned
parts. Be sure the trigger moves freely.
6. Never use halogenated hydrocarbon solvent, as it can chemically react with
aluminum and zinc parts of this tool.
7. Do not make any modifications to this tool.
Figure 1:

ATD AIR ATD-6901 Specifications

General

Brand	ATD AIR
Model	ATD-6901
Category	Paint Sprayer
Language	English

Summary

Important Safety Instructions

Personal Protective Equipment

Always wear eye protection, gloves, and respirator to prevent against harmful vapors while spraying.

Propellant Restrictions

Never use oxygen or any other combustible or bottle gas as a propellant. Explosion may result.

Flammability Precautions

Use the spray gun only in well-ventilated areas, do not smoke or use near open flame.

Air Supply Disconnection

Always disconnect the paint gun from air supply when not in use and during maintenance.

Pre-Use Tool Inspection

Inspect the tool before each use for leakage or misaligned parts. Ensure trigger moves freely.

Solvent Material Compatibility

Never use halogenated hydrocarbon solvent, as it can react with aluminum and zinc parts.

Unauthorized Modifications

Do not make any modifications to this tool.

Operating Instructions

Power Source Requirements

Tool operates best on clean, dry compressed air at 29 to 50 psi. Moisture filter is recommended.

Tool Preparation Steps

Check for worn parts, trigger movement, connect to air, adjust pressure, and clean before use.

Gun Handling Techniques

Keep gun perpendicular to surface and moving side-to-side at a constant distance for optimal results.

Adjustment Controls

Fine-Tuning Settings

Fine-tune spray patterns, fluid output, and atomization using the three illustrated controls.

Maintenance and Cleaning

Gun Cleaning Procedure

Clean paint cup, cap, spray head, needle, and nozzle with thinner until clean.

Exterior Cleaning and Needle Seat Care

Wipe exterior with cleaning brush and cloth moistened with thinner. Protect the needle seat.