ATD AIR ATD-6903 User Manual

1
ATD-6903
1.0MM TOUCH UP GUN W/CUP
INSTRUCTION MANUAL
Read this manual carefully and understand it completely.
Retain manual for future use.
Always follow safety precautions to prevent personal injury and/or damage
to the equipment.
Illustrations and photos are intended for reference only. Actual product may vary.
Specifications are subject to change without notice.
Important Safety Instructions
1. Always wear eye protection, gloves and respirator to prevent against harmful
vapors while spraying.
2. Never use oxygen or any other combustible or bottle gas as a propellant.
Explosion and serious injury or death may result.
3. Many paints and solvents can be highly flammable. Please use the spray gun
only in well-ventilated areas, do not smoke or use near open flame.
4. Always disconnect the paint gun from air supply when not in use and during
maintenance. For emergency stopping and to prevent unintended operation, a
valve near the gun is recommended.
5. Inspect the tool before each use to ensure there is no leakage or misaligned
parts. Be sure the trigger moves freely.
6. Never use halogenated hydrocarbon solvent, as it can chemically react with
aluminum and zinc parts of this tool.
7. Do not make any modifications to this tool.
Figure 1:

ATD AIR ATD-6903 Specifications

General

Brand	ATD AIR
Model	ATD-6903
Category	Paint Sprayer
Language	English

Summary

Important Safety Instructions

Personal Protective Equipment

Wear eye protection, gloves, and respirator to prevent against harmful vapors while spraying.

Propellant Gas Warning

Never use oxygen or any other combustible or bottle gas as a propellant; risk of explosion.

Flammable Material Handling

Use spray gun in well-ventilated areas, do not smoke or use near open flame.

Air Supply Disconnection

Disconnect the paint gun from air supply when not in use or during maintenance.

Pre-Use Tool Inspection

Inspect tool for leaks, misaligned parts, and ensure trigger moves freely.

Solvent Compatibility

Never use halogenated hydrocarbon solvent, as it reacts with tool parts.

Tool Modification Prohibition

Do not make any modifications to this tool.

Operating Instructions

Power Source Requirements

Tool operates on clean, dry compressed air at 29 to 50 psi; moisture filter recommended.

Tool Preparation

Check for damage, connect air, adjust pressure, clean gun, and pour paint into cup.

Spray Gun Handling

Keep gun perpendicular, move steadily, maintain 6-12 inches distance from surface.