5. Inspect the tool before each use to ensure there is no leakage or
mis-aligned parts. Be sure trigger moves freely.
6. Never use homogenate hydrocarbon solvent as it can
chemically react with the aluminum and zinc parts of this tool.
7. Do not make any modifications to this tool.
Figure1:
Operating Instructions
POWER SOURCE
This tool operates best on a clean, dry supply of compressed air
delivered at 21 to 43.5 PSI. Use of a moisture trapping air filter is
highly recommended as moisture or foreign matter can damage the
internal parts tool.
CAUTION: All air pressure in the system should be rated at 21 to
43.5 PSI. Higher or lower pressure can adversely influence the
operation of or cause damage to the tool.
NOTE: To maintain a maximum 10 PSI at nozzle, use a maximum
of 43.5 PSI at the inlet.
To Next Page
Loading...