ATD Tools ATD-6900 User Manual

ATD-6900
10PCS HVLP SPRAY GUN SET
INSTRUCTION MANUAL
Read this manual carefully and understand it completely.
Retain manual for future use.
Always follow safety precautions to prevent personal injury
and/or damage to equipment.
Illustrations and photos are intended for reference only. Actual
product may vary. Specifications subject to change without notice.
Important Safety Instructions
1. Always wear eye protection, gloves and respirator to protect
against harmful vapors produced when spraying.
2. Never use oxygen or any other combustible or bottled gas as a
propellant. Explosion and serious injury or death may result.
3. Many paints and solvents can be highly flammable. Use spray
gun only in well ventilated areas. Do not smoke or use near
open flame.
4. Always disconnect tool from air source when not in use and
during maintenance. For emergency stop and to prevent
unintended operation, a valve near the tool is recommended.

ATD Tools ATD-6900 Specifications

General

Nozzle Size	1.4 mm
Operating Pressure	29 PSI
Cup Size	600 cc
Air Inlet Size	1/4 inch
Type	HVLP Spray Gun
Material Cup Capacity	600 cc

Summary

Important Safety Instructions

Eye, Glove, and Respirator Protection

Wear protective gear to shield against harmful spray vapors.

Propellant Safety

Avoid using oxygen or combustible gases as propellant due to explosion risk.

Flammability and Ventilation

Use in ventilated areas, avoid flames due to flammable paints/solvents.

Disconnect and Emergency Stop

Disconnect air source when not in use or for maintenance.

Operating Instructions

Power Source Requirements

Specifies clean, dry compressed air supply and recommended pressure range (21-43.5 PSI).

Tool Preparation

Initial Tool Inspection

Check for worn or damaged parts and ensure the trigger moves freely.

Air Supply Connection

Connect the tool to the air supply system.

Air Pressure Adjustment

Adjust air pressure based on paint viscosity and manufacturer's recommendations.

Paint Loading

Pour paint into the spray gun cup.

Gun Handling Guidelines

Spray Gun Orientation

Keep the spray gun perpendicular to the surface for optimal results.

Spraying Motion

Maintain continuous gun movement from side to side while spraying.

Adjustment Settings

Fine-Tuning Controls

Adjust spray pattern, fluid output, and atomization using three controls.

Maintenance Procedures

Gun Cleaning Process

Clean gun with thinner, including cup, cap, spray head, needle, and nozzle.