Ateco AT-301 - ATECO AT-301 System Overview

Contents
1. ATECO AT-301 General Introduction..........................................................................................1
1.1 Functional Components........................................................................................................ 1
1.11 AT-301sensor............................................................................................................... 1
1.12 Control Box.................................................................................................................2
1.2 Technical Specifications........................................................................................................3
1.3 Sharing the Sensor Between Rooms..................................................................................... 3
1.4 Using the different Positioning Systems..............................................................................3
2. Imaging Software General Introduction........................................................................................ .4
2.1 Computer System Requirements...........................................................................................4
2.2 Imaging Software................................................................................................................. .4
3. Driver Installation.......................................................................................................................... .5
4. Software Installation...................................................................................................................... .7
5. Register Key..................................................................................................................................11
6. Install Calibration File...................................................................................................................12
6.1 Install to Atecotech.........................................................................................................12
7. Software Operation......................................................................................................................13
8. Acquiring an Image....................................................................................................................... 20
8.1 Preparing the AT-3 01sensor................................................................................................ 20
8.2 Preparing for Acquisition.................................................................................................... 20
8.3 Launching the X-Ray.......................................................................................................... 21
9.Ateco Image..................................................................................................................................22
10. Troubleshooting Images.............................................................................................................. 33
11 Maintenance................................................................................................................................. 36
11.1 Visual Inspection............................................................................................................... 36
11.2 Periodic Maintenance........................................................................................................36
11.3 Cable Care........................................................................................................................36
11.4 Damaged or Non-Functioning Sensor..............................................................................36
12. Warranty...................................................................................................................................... 37
13. Notice.......................................................................................................................................... 37
13.1 Indication of Use............................................................................................................... 37
13.2 Brief Introduction of this Manual..................................................................................... 37
13.3 Manufacturer..................................................................................................................... 37
13.4 Packinglist......................................................................................................................... 37
13.5 Symbols.............................................................................................................................38
14. Safety issue..................................................................................................................................39
14.1 Check Sensor and controller before using them............................................................... 39
14.2 Protect Sensor from Potential ESD Damage.................................................................... 39
14.3 Do Not Touch Exposed Connectors on Non-Medical Equipment and the Patient at the
Same Time.................................................................................................................................39
14.4 Ensure Proper System and PC Workstation Installation and Operation...........................39
14.5 Safety Classifications........................................................................................................ 40
14.6 Conditions required in operation, transportation, and storage......................................... 40