based on ATECO Server software. The computer must have the ATEC O Dentist
dental imaging software, and ATECO Server must installed in one computer.
To share the sensor between several computers, move it from room to room. When
you connect the sensor to a USB 2.0 port on the computer, the sensor is recognized
automatically and is operational.
To share data between rooms, you can connect them to remote data---ATECO Server
database. The ATECO Dentist dental imaging software needs only to access a shared
database on the same computer or on a remote computer, which means ATECO Server
database.
1.4 Using the different Positioning Systems
There are two ways to position the sensor in the patient mouth to get an classic
radiology. You may spend some time to adapt due to the rigidity of the sensor.
One method is angular bisector technique, the other method is paralleling technique. It
is just the way to position sensor, which can be chosen by practitionerās experience.
X-Ray Generator Compatibility
Normally, the sensor is compatible with all generators which meets the present
standard of intraoral radiology. You can use a high frequency or conventional
generator. To achieve gaining better images, the generator must operate with a voltage
of 65 to 70kV.
1.5 Attentions
1 As a precision devices, avoid flop,pulling and long-time disinfectant soak
To Next Page