EasyManua.ls Logo

atecpool Brightbot 6000 - Manual Mode Operation; Manual Switch Control; Mine Section Overview; Daily Maintenance Procedures

Default Icon
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN EN
11 12
Daily Maintenance
1
Clean the filter basket
1.1 Open top cover of the rober, and take out the filter basket.
2
Disasseble and replace the filter board
2.1 Take net bag out of the filter basket first.
2.2 Disassembly: Press the filter basket with hands, and then pull out the filter
boards surrounding the filter basket in the sequence of 1F→2B→3L→4R upward.
2.3 Instalation: Install the new filter board in the filter basket in the sequence of 4R
→3L→2B→1F, and then the replacement is completed.
1.2 Flush inside and outside of the filter basket with a water gun.
1.3 Place the filter basket back to the cleaner upon cleaning.
Note: Before cleaning, the cleaner shall be disconnected from the power supply first, and
the filter basket shall be cleaned timely every time after use, so as to avoid impact on the
cleaning property.
Note: Superfine paper-element filter board is a fragile product, and can filter smaller
particular contaminants, therefore, in order to guarantee cleaning property of the
cleaner, it is suggested replacing the superfine paper-element filter board at least once
every three months if using the cleaner.
5
Manual mode
4R
2B
1F
3L
4R
2B
1F
3L
Manual mode
9:41
Homepage
Appointment
Manual
Mine
Mine
9:41
Homepage
Appointment
Manual
Mine
Store
Video teaching
Help and feedback
Setting
History
About
Firmware upgrade
6
Mine
Manual switch
Control movement
of the cleaner via a
remote-control
lever