PDU Mounting Kit
Select the mounting kit you are installing below. Use
the front side instructions to secure the brackets to the
PDU. Use the back side instructions to install the PDU
on the rack.
Slide Rail Mount
Button Mount
Side Panel Mount
Step 1 - Turn the PDU over, align the
top center hole, and screw the slide
rail to the PDU.
Screw
Step 2 - Push the sliding rail to
expose the second hole and
tighten the second screw.
Screw
Push
Slide
Step 3 - Repeat at the other
end of the PDU.
Step 1 - Using the center holes,
secure the mounting brackets to
both ends of the PDU with the
screws provided, as shown below.
Step 1 - Turn the PDU over and
screw the two round spacers to
the center at each end of the
PDU, as shown below.
Bracket Installation:
Part No. PAPE-1205-B00G
To Next Page
Need help?
General
