C
Step 5 - The tool will vibrate/beep after
receiving the sensor information. The
tool will display the sensor ID, pressure,
and sensor state of the valve that is
triggered. If the tool does not receive the
correct information, the fail LED will
illuminate and you can restart the trigger
sequence by pressing the
key
again.
CHRYSLER
LEFT FRONT
6FF79 32.24 PSI
78°F 1.0 g
BAT:OK 315 MHz
(C) MENU
(T) START
( ) NEXT
Low Bat Pass Fail Tx
Step 6 - Follow the same procedure for
the rest of the three or four wheels by
pressing the
key and then
key.
(Refer to vehicle owners manual or other
refere
nce guides for TPM reset procedure.)
To Next Page
Loading...
Need help?
General