ATEQ VT30 - Section C - TRIGGERING SENSOR(S); C1

To Next Page

To Previous Page

SECTION C - TRIGGERING SENSOR(S)

C1 - TESTING A TPM SENSOR

Step 1 – Select the "VEHICLE

SELECTION" menu and confirm selection

with the

key.

MAIN MENU

>VEHICLE SELECTION

RKE TEST

SETTINGS

Step 2 – Select the vehicle brand on the

screen by using the

or keys

and confirm selection with the

key.

VEHICLE SELECTION

>FORD

GEELY

Step 3 - Hold the tool within a few inches

from the TPM sensor. Some sensor may

require the tool position directly on the

rubber tire, over the valve stem.

Note: Some sensors are banded to the wheel and can be located 180° opposite the

valve stem. (Refer to owners manual)

Step 4 - Press the key. The tool will

begin to send LF trigger and the TX light

will flash. Depending on the sensor, the

tool will activate the sensor on the first or

last step. Each step identifies the

number of valve types used on the

vehicle brand.

FORD

LEFT FRONT

STEP: 2 / 4

TRIGGER PROCESSING

Low Bat Pass Fail Tx

ATEQ VT30 - Section C - TRIGGERING SENSOR(S); C1 - Testing a TPM Sensor