VT36 TPMS TOOL user guide
UM-36400C-U User manual ATEQ VT36 Page 26/32
MISCELLANEOUS
1. CHARGE
Low Battery Indication
Your TPMS TOOL incorporates a low battery
detection circuit. Battery life is an average of 400
sensor tests per battery full charge
(approximately 80-100 cars).
A full charge is about 6 hours.
BATTERY LEVEL
When battery is low, the battery screen is
flashing with the message "LOW".
The power button may also be pressed and held
for a second to display battery status.
BATTERY LEVEL
LOW
Battery Charging
Fig. 6
When the battery is low, the “status bar” appears every 10 seconds. This display will stop
when the battery loses power.
Plug the USB cable between the tool and the charger adapter, and then plug the charger
adapter in an appropriate outlet. The red LED "CHARGE" light will turn on.
It’s not recommended to use the tool with low
battery status because the transmission and
emission may not be reliable.
Once charged, the bar graph is full and the LED
"CHARGE" turns to green light.
BATTERY LEVEL
Battery replacement
The tool must be returned to the factory for battery replacement.
Opening the tool or tampering with the seal placed on the tool, if broken will void
the warranty
USB Power
supply connector
To Next Page
Loading...