ATEQ VT5 User Manual

Spark Tire Rotation and TPMS Reset SRTViperDude
This guide will show you how to swap wheels and tires, rotate the tires, or do anything that
involves resetting the TPMS sensors. Contrary to popular belief, it is not necessary to bring
your car to a dealer to have the TPMS system reset. The tire pressure reset tool shown below
can be used when performing a wheel swap, rotating the tires, or to clear a TPMS warning light.
ATEQ Tire Pressure Reset Tool:
Whenever the location of the wheels change, the TPMS system needs to be reset so the car can
track the relative position of each wheel. This is how the OnStar report knows which tire has
low air pressure or which tire is flat. Also, if the tire pressure sensors are removed or replaced,
such as when changing wheels, the TPMS system needs to be reset.

ATEQ VT5 Specifications

General

Frequency	315 MHz, 433 MHz
Languages Supported	Multiple languages
Type	Tire Pressure Monitoring System (TPMS) Diagnostic Tool
Display	LCD screen
Update Method	USB
Power Source	Rechargeable battery
Features	TPMS sensor activation, reading, and programming
Function	TPMS sensor service and diagnostics
Operating Frequency	315 MHz, 433 MHz
Operating Temperature	0°C to 50°C (32°F to 122°F)
Compatibility	Works with most vehicles equipped with TPMS

Summary

TPMS Reset and Tire Rotation Guide

Understanding TPMS Reset Requirements

Explains why TPMS sensors need resetting after wheel changes or for warning lights.

Required Tools and Preparations for Tire Service

Essential Tools for Wheel Rotation and Replacement

Lists required tools such as floor jack, jack stands, air compressor, and TPMS reset tool.

Optional Security: Wheel Locks

Suggests using wheel locks for theft prevention and carrying the key.

Safe Vehicle Lifting and Support

Vehicle Preparation Before Lifting

Ensures the car is on a flat surface with the parking brake set and in gear.

Proper Jacking and Jack Stand Usage

Details using jacks and stands correctly, emphasizing never getting under a jack-only supported vehicle.

Wheel Replacement and Lug Nut Tightening

Wheel and Lug Nut Removal Process

Describes the process of removing lug nuts and lifting the wheel off the studs.

New Wheel Installation and Lug Nut Securing

Covers fitting the new wheel, tightening lugs in a cross pattern, and using a torque wrench.

TPMS Sensor Pairing Procedure

Necessity of TPMS Sensor Re-Pairing

Explains why TPMS sensors need re-pairing after wheel changes or sensor replacement.

Initiating TPMS Learning Mode via Vehicle Controls

Details setting parking brake, turning ignition to ON/RUN, and navigating display to 'tire LEARN'.

Sequential TPMS Sensor Pairing

Guides using TPMS tool on each wheel sequentially until horn honks, confirming pairing.

Finalizing TPMS Pairing and Setting Tire Pressure

Instructs on turning off ignition and setting all tires to recommended PSI.