Using the Ather
Charging Cable
Switch off the vehicle & pull out the vehicle key
Plug in the 3 pin connector of the charging cable
into the 5 amp socket.Plug in the other end of the
cable to the vehicle’s charging port.
To plug out turn the key ON, this will unlock the
connector. While the key is in the ON mode,
remove the charging connector and close the
charging port flap
Remove the key once your vehicle is connected to
charger/disconnected from the charging cable.
Do not turn the key ON and pull out the connector,
at the same time. Hold on for a second or two.
Do not attempt to remove connector while your scooter is
charging, you run the risk of damaging the connector or
the scooter.
CAUTION
46
To Next Page
Loading...
