To Next PageTo Next PageWhat to do if 100% calibration failed on ATI Technologies Measuring Instruments?
If the 100% calibration fails on your ATI Technologies Measuring Instruments, first verify the aerosol source. If the issue persists, try using a higher concentration as the 100% reference.
General| Brand | ATI Technologies |
|---|---|
| Model | 2H |
| Category | Measuring Instruments |
| Language | English |
Specifies environmental and power conditions for proper operation of the 2H Aerosol Photometer.
Instructions for carefully unpacking the 2H Aerosol Photometer and verifying all included items.
Identifies and describes the various ports, controls, and indicators on the front panel of the 2H.
Details the function keys, displays, and LED indicators on the 2H's front panel.
Explains how to properly connect the optional Scanning Probe to the 2H unit.
Identifies and describes the components and connectors located on the rear panel of the 2H.
Details the RS-232 port located on the side of the unit for data output.
Guides the user through the power-up sequence and initial setup for the 2H Aerosol Photometer.
Lists and describes the twelve operating parameters, including those programmable by the operator.
Provides step-by-step instructions for modifying the 2H's programmable setup parameters.
Explains how to configure the unit's alarm feature for particle concentration alerts.
Details the procedure for selecting or re-establishing the internal reference for measurements.
Outlines the process for measuring upstream aerosol concentration using specific challenge aerosols.
Describes how to measure % leakage using a user-defined reference point.
Provides instructions on performing tests with the 2H unit after baselines are established.
Explains how to check upstream aerosol concentration during testing operations.
Details the routine weekly maintenance tasks required for the 2H Aerosol Photometer.
Outlines annual maintenance, including factory calibration and cleaning recommendations.
Covers general maintenance, user-serviceable parts like fuses and filters.
Lists spare components that can be ordered for user field replacement.
Instructions for cleaning the wire screens on the scanning probe.
Step-by-step guide for replacing the power fuses in the 2H unit.
Instructions for replacing the HEPA exhaust filter on the rear panel.
