6
POSITIONING
Install the appliance in a room protected against frost.
• When mounting the appliance, check that the wall is capable of supporting the weight of the
appliance filled with water (a 30-litre water heater weighs about 40 kg when full).
If the appliance is to be installed in a damp room or location where the ambient temperature is
constantly above 35 °C, ensure that the room is correctly ventilated.
• Installation in the bathroom: There are 4 designated areas designated for the installation of
appliances following their characteristics.
Our electric water heaters can be installed:
- outside areas 0 and 1 for products above sinks,
- outside areas 0, 1 and 2 for products under sinks,
referenced below depending on their category in accordance with the installation instructions of
standard NF C15-100, table 701A and rule 701, figures 701A and 701B. (FIG. 1 below)
(FIG.1)
MOUNTING AN APPLIANCE
Wall mounting: fasten the bracket to the wall using pre-sealed M6 studs and M6 nuts.
The mounting orientation of a water heater above a sink or below a sink cannot be
inverted. (FIG. 2 and 3 below).
To Next Page
Loading...
