What to do if Atlantic Water Heater shows Err W.7?
If your Atlantic Water Heater displays the error code Err W.7, it indicates either there is no water in the tank, or the ACI connection is open. First, fill the tank with water. Then, check the ACI circuit, including the AC connection, wiring, and water conductivity.
How to fix Err H.15 on Atlantic Water Heater?
The Err H.15 error code on your Atlantic Water Heater means the date and time have not been set. To resolve this, simply enter the correct date and time into the system.
Why does my Atlantic Water Heater show Err W.10?
The Err W.10 error code on your Atlantic Water Heater indicates a communication problem between the control panel and the power board. You should check the connections and connection cables between the control panel and the power board.
What does Err W.3 mean on Atlantic Water Heater?
The error code Err W.3 on your Atlantic Water Heater means that the middle tank sensor is defective or the temperature is outside of the measuring range (less than 0° C or greater than 85° C). Here's what you should do: * Check the connections and ensure the sensor is correctly positioned. * Check the sensor's ohmic value. * If the issue persists, replace the sensor.
How to solve Err W.11 error on Atlantic CALYPSO Water Heater?
The Err W.11 error on your Atlantic Water Heater indicates that there is no off-peak signal detection. To solve this: * Check the wiring for the transmission of the off-peak time signal. * Change the activation settings.
What to do for Err W.17 on Atlantic Water Heater?
The error code Err W.17 on your Atlantic Water Heater indicates that the top tank sensor is defective or the temperature is outside of the measuring range (less than 0 °C or greater than 110 °C). Here's what you should do: * Check the connections and ensure the sensor is correctly positioned. * Check the sensor's ohmic value. * If the issue persists, replace the sensor.
Details permanent operation or internal programming usage for electrical setup.
Details off-peak hours or photovoltaic panel operation for electrical setup.
Describes connecting the cold water inlet.
Describes connecting the hot water outlet.
Instructions for condensate evacuation.
Guidance on choosing the appropriate location for installation.
Specifies the minimum required surface area for the installation room.
Details restrictions on ventilation grilles.
Provides guidance on the placement of the unit.
Instructions for installing the water tank.
Details on making the hydraulic connections.
Instructions for connecting the refrigerant lines.
Details on making the electrical connections.
Configuration options for the unit after installation.
General| Heating Element | Copper |
|---|---|
| Voltage | 230V |
| Type | Electric |
| Mounting | Wall-mounted |
| Tank Material | Enamelled Steel |
| Control Type | Mechanical |
| Capacity | 50 liters |
| Warranty | 5 years |
| Diameter | 433mm / 433mm / 433mm / 505mm (depending on capacity) |
To Next Page