Trouble Shooting Guide
Hard water
Make sure that the power is connected (one light
on the fascia panel should be on).
If no lights are on, then the power is turned off,
the power connector at the back of the softener
has been unplugged, or the transformer is faulty.
If the plug-in transformer is warm, it is probably
working.
Check that the inlet/outlet hoses are connected
the right way around.
Check that the bypass valve is shut and the inlet /
outlet valves are open.
Check that there is salt in the salt container. Ch
ec
k
also, that the salt hasn't built up a 'crust' inside
the container – if it has, break it up and rinse it
away.
If you have a tank in the loft ensure that the float
valve is not blocked or filling very slowly.
Check the hardness setting on the fascia panel is
correct (instructions are on the hardness test kit
supplied).
Use the hardness test kit to confirm your
suspicion that the water is hard.
Make sure that the lights flash from left to right
across the fascia panel when water flows
th
rough
the softener.
See the back cover of this manual for a diagram of the rear
view of the water softener.
To Next Page
Loading...
