Instruction book
56 6996 0227 40
Move the cursor to the Password icon (see above, section Menu icon)
Select Modify using the Scroll keys and press the Enter key. Next, modify the password as required.
3.17 Web server
Getting started
All Elektronikon Mk5 controllers have a built-in web server that allows direct connection to the company
network or to a dedicated PC via a local area network (LAN). This allows to consult certain data and
settings via a PC instead of the display of the controller.
If the compressor is equipped with a SMARTBOX, the network connection of the Elektronikon is already in
use. To allow the web server functionality, the network cable that is connected to the SMARTBOX should
be unplugged and replaced by the cable of the company network. If both the web server functionality and
SMARTBOX are required, please contact your local Atlas Copco Customer Centre for support.
Configure a dedicated PC connection
Make sure you are logged in as administrator to change IP settings.
Use the internal network card from your computer or an USB to LAN network card.(see picture)
Use an UTP cable (CAT 5e) to connect to the controller. (see picture)
Configure the network card
Go the ‘Network and Sharing Center’:
To Next Page
Loading...
