- 10 -
Service safety
Before servicing
• Never perform even routine service (such as
changing oil and filters, or cleaning the engine)
unless all electrical components are shut down:
- Ensure all light tower power circuits are shut
off.
- Turn the engine key to OFF and set all circuit
breakers to the OFF position.
- Disconnect cable from negative terminal on
battery.
• If the ground under or around the trailer is damp or
wet, move the trailer to a dry location and allow it
to dry before servicing. Do not allow water to
accumulate around the base of the light tower.
• Do not service the light tower if clothing or skin is
wet.
During servicing
• Keep hands, feet, and loose clothing away from
moving parts on engine and generator.
• Keep the light tower and all its components clean.
• Keep labels legible. Replace damaged or missing
labels. (Replacement labels are available from the
factory.)
• When hoisting or loading the trailer:
- Ensure devices such as slings, chains, hooks,
ramps, and jacks are secure and will bear the
weight of the trailer. The trailer’s gross vehicle
weight rating (GVWR) is displayed on the
light tower vehicle identification tag.
- Be aware and cautious of people’s proximity
to the trailer. Always ensure the safety of
nearby people.
DANGER
High voltage.
Contact with live electrical
circuits will cause severe
injury or death.
- Turn off power before
servicing any component
on the light tower.
- Only a qualified electrician
should service the light
tower electrical system.
To Next Page
Loading...
