Atlas Copco LF 3 User Manual

2920 7090 00 67
Instruction book
DECLARATION OF INCORPORATION
2
We, Atlas Copco Airpower n.v., declare under our sole responsibility, that the product
3
Machine name
4
Machine type
5
Serial number
6
7
must not be put into service until the machine in which it is intended to be incorporated into or assembled with, is in
conformity with the relevant Essential Health and Safety Requirements of the EC-Directive 2006/42/EC and its
amendments on the approximation of the laws of the Member States relating to Machinery.
EC DECLARATION OF CONFORMITY
We, Atlas Copco Airpower n.v., hereby declare that the product which falls under the provisions of article 12.2 of
the EC Directive 2006/42/EC on the approximation of the laws of the Member States relating to machinery, as a
component/quasi machine is in conformity with the relevant Essential Health and Safety Requirements of this
directive.
We, Atlas Copco Airpower n.v., undertakes, in response to a reasoned request by the national authorities, to
transmit the relevant information on the partly completed machinery. The information on the relevant parts can be
obtained prejudice to the intellectual property rights of Atlas Copco Airpower N.V.
The machinery complies also with the requirements of the following directives and their amendments as indicated.
Directive on the approximation of laws of the
Member States relating to
Harmonized and/or Technical
Standards used
Att’
mnt
a.
Pressure equipment 97/23/EC
b.
Machinery safety 2006/42/EC
EN ISO 12100 – 1
EN ISO 12100 – 2
EN 1012 – 1
EN 60204-11
c.
Simple pressure vessel 2009/105/EC
d.
Electromagnetic compatibility 2004/108/EC
EN 61000-6-2
EN 61000-6-4
e.
Low voltage equipment 2006/95/EC
EN 60034
EN 60204-1
EN 60439
f.
Outdoor noise emission 2000/14/EC
8
9
10
11.a
The harmonized and the technical standards used are identified in the attachments hereafter
11.b
Atlas Copco Airpower n.v. is authorized to compile the technical file.
12
13
Conformity of the specification
to the directives
Conformity of the product to the
specification and by implication to the
directives
14
15
16
Issued by Engineering Manufacturing
17
Name
Ferdinando
MARCHETTI
Rik
VAN DE VELDE
18
Signature
19
Date
Typical example of a Declaration of incorporation for block document
(1): Contact address:
Atlas Copco Airpower
n.v. P.O. Box 100
B-2610 Wilrijk
(Antwerp) Belgium

Atlas Copco LF 3 Specifications

General

Brand	Atlas Copco
Model	LF 3
Category	Compressor
Language	English