Atlas Copco PHE 6 H

14
PAGE
Repair Instructions No.181.03/98
PHE 6 H / PHE 6 S
PHE 6 H:
Assembling the
spindle sleeve
1 Insert a new O-ring (C) into the retainer (5)
and fit the retainer to the barrel (B).
2 Grease the anvil (9) and fit two new seal
rings (8).
☞
Take care that the seal rings are not
twisted.
3 Fit the ring (7) and the rubber ring (6) to
the anvil (9).
4 Insert the anvil (9) into the driver (4).
5 Mount the spring ring (3).
6 Press the ball bearing (2) onto the driv-
er (4) and secure it with the spring ring (1).
PHE 6 H:
Assembling the
driver and the
barrel
1 Grease the barrel (1) and screw down the
driver (2).
2 Fix the service tool (4) in a vice (5).
3 Insert the barrel (1) and the driver into the
service tool and fasten the two with an Al-
len key (3) (30 Nm).
1
7
6
5
4
2
8
9
A
BC
3
9
1
5
4
2
3
2 1
10