- 15 -
Position I: Voltage is applied to the Qc1002™
module, it is possible to start up the generator.
X7 ... Flanged Inlet
Used to supply power to the available coolant
heater or battery charger (if ordered).
X25 .. Terminal strip
Qc1002™ Module
The Qc1002™ module is located inside the control panel.
This control module will carry out all necessary tasks to
control and protect a generator, regardless of the use of the
generator.
This means that the Qc1002™ module can be used for
several applications.
Pushbutton and LED functions
Following pushbuttons are used on the
Qc1002™
ENTER: Is used to select and
confirm changed settings in the
Parameter list.
UP: Is used to scroll through the
display information and to adjust
parameter value upwards.
DOWN: Is used to scroll through the
display information and to adjust
parameter value downwards.
BACK: Is used to leave the Alarm
pop-up window, to leave the
Parameter list and to leave menu's
without change.
REMOTE MODE: Is used to
activate the remote mode. The LED
indicates if the gen-set is put in
Remote Mode.
START: Is used to start the unit in
Manual Mode.
STOP: Is used to stop the unit in
Manual or Remote Mode (always
with shutdown!). When the unit is
stopped with the STOP button in
Remote mode, it will automatically go
to Manual Mode.
To Next Page
Loading...
