- 27 -
After selection of SP the following view will be visible:
If the correct password is entered, the following view
appears:
Now the user can change the SP of parameter “G-P>1”.
This can be done with the scroll buttons. Then the user has
to select SAVE to save the new settings.
To exit the user has to press the BACK button several
times, until the main view appears.
The JUMP button
Instead of navigating through the entire menu, the user can
jump directly to the required parameter, if he knows the
channel number of that specific parameter.
If the JUMP button is pushed the password view will
appear. Not all parameters can be changed by the end-user.
The required password level for each parameter is given in
the set point list.
The following menus can only be reached using the JUMP
button:
– 9000Software version
– 9020Service port
– 911XUser password
Level 2 and Level 3 passwords can only be set through the
Atlas Copco Utility Software PC Software.
– 9120Service menu
– 9130Single/Split/Three phase
– 9140Angle comp. BB/G
Use the UP and DOWN buttons to change the settings and
the SEL button to store the new setting.
To Next Page
Loading...
