Atlas Copco QLT H50 Kd ESF - Page 6

- 6 -
4.2.6.3 Switching on/off the
floodlights automatically.................31
4.2.7 Lowering the mast ...........................31
4.2.8 Stopping the engine ........................32
4.3 Connecting appliances ....................33
4.4 Setting the Lc1003™ controller......34
4.4.1 Pushbutton and LED functions........34
4.4.2 Module display.................................35
4.4.2.1 Home page .......................................35
4.4.3 Icon overview ...................................35
4.4.3.1 Instrumentation icons......................35
4.4.3.2 Active configuration.........................36
4.4.3.3 Front panel editor (FPE) / Auto
Run icons ..........................................36
4.4.3.4 Mode icons .......................................36
4.4.3.5 Light output icons ............................36
4.4.3.6 Alarm icons.......................................36
4.4.4 Navigation menu..............................37
4.4.5 Event log ...........................................37
4.4.6 Setting the Lc1003™ timer ..............37
5 Periodic maintenance .................39
5.1 Maintenance schedule.....................39
5.1.1 Precautions .......................................44
5.1.2 Use of maintenance schedule.........44
5.1.3 Use of service paks ..........................44
5.2 Preventing low loads.......................45
5.2.1 General..............................................45
5.2.2 Risks of low load operation.............45
5.2.3 Best practices ...................................45
5.3 Maintenance of the alternator........45
5.3.1 Measuring the alternator
insulation resistance ........................45
5.4 Engine maintenance procedures....46
5.4.2 Engine oil level check.......................46
5.4.3 Engine oil and oil filter change .......47
5.4.4 Coolant check ...................................48
5.5 Adjustments and service
procedures........................................49
5.5.1 Battery care.......................................49
5.5.2 Replacing fuel filter and pre-
filter element.....................................51
5.5.3 Servicing air filter engine ................51
5.5.4 Air cooling circuit .............................52
5.5.5 Replacing the lamps.........................52
5.5.6 Ordering spare parts........................53
5.6 Resetting service alarms .................53
5.7 Engine consumable
specifications....................................53
5.7.1 Engine fuel specifications................53
5.7.2 Engine oil specifications..................53
5.7.3 Engine coolant specifications..........54
6 Checks and trouble
shooting
..........................................55
6.1 Engine troubleshooting...................56
6.2 Solving controller alarms ................56
6.2.1 General..............................................56
6.2.2 Alarm overview ................................57
7 Options available for QLT
H50 units
.........................................63
7.1 Overview of the mechanical
options ..............................................63
7.2 Description of the mechanical
options ..............................................63
7.2.1 Undercarriage...................................63
7.3 Overview of the electrical
options ..............................................64
7.4 Description of the electrical
options ..............................................64
7.4.1 Auto mast down system..................64
7.4.2 Photocell ...........................................65
7.4.3 External power input (230
VAC), with battery charger ..............66
7.4.4 Override fuel shutdown ...................68
7.4.5 Earth pin............................................68
8 Storage of the light tower.........69
8.1 Storage..............................................69
8.2 Preparing for operation after
storage ..............................................69
9 Disposal...........................................70
9.1 General..............................................70
9.2 Disposal of materials .......................70