Installation EN SDS
16
© Atlas Copco Industrial Technique AB - 9836 794200 00
Step 16 (Picture P)
Legend
1. Hex key
• Close the top gate.
Note: ensure gate does not make contact with the rail; leave a gap be-
tween the rail and gate as to not allow a screw to pass.
Turn top gate screw counter clockwise to close.
DO NOT REMOVE SCREW!
Step 17
• Connect AC adaptor to the Feeder.
• Plug AC adaptor into outlet.
• Turn switch “ON”.
Step 18
• Place some screws into the feeder and power on.
• Make sure the screws are sliding down the rail smoothly.
• Make sure you can pick up the screws smoothly from the front with your
screwdriver.
Step 18
• Place the cover back to its original position.
Keep cover on at all times when screw feeder is in use.
Additional adjustments (Picture Q)
To adjust the Vibrator, Roller or Swing strength function, you need a small
cross screwdriver (3mm) or a small flat screwdriver.
Overload Alarm
This adjustment allows you to switch on and off the alarm that indicates when
an overload is occurring.
Vibrator (Vibration Timer)
This adjustment allows you to determine the vibration time after a screw has
reached the pick up point of the feeder.
Roller (Drum Timer)
This adjustment allows you to determine the time in which the drum will feed
screws into the rail after a screw has reached the pick up point of the feeder.
Swing Strength (Vibration Intensity)
This adjustment allows you to control the intensity of the vibration of the
feeder.
Recommended screw capacities
To ensure you do not overload your screw feeder, please follow the recom-
mended fill level for your screw length.
See Picture R
1. Screw length ≤ 10 mm
2. Screw length ≤ 15 mm
3. Screw length ≤ 19 mm
To Next Page
Loading...