Introduction STa 6000 User Guide
14 (324) 9836 8243 01 Edition 3.1
Part Name Description
Chapter 12 Results Viewer This chapter explains how to retrieve the test results from
the instrument.
Chapter 13 Trace Viewer This chapter explains how to retrieve the test traces from
the instrument.
Chapter 14 Statistics This chapter shows the SPC and Cm-Cmk statistics
produced by the STa 6000 and ToolsTalk BLM.
Chapter 15 Offline Programming This chapter explains how to define tightening programs
and STa 6000 configuration offline, to transfer then the
file to one or more STa 6000.
Chapter 16 STa 6000 Settings This chapter explains how to setup the STa 6000 and its
accessories.
Chapter 17 Working with Torque
Supervisor
This chapter explains the use of the STa 6000 with
Torque Supervisor.
Chapter 18 Working with IRC-Connect This chapter explains the use of the STa 6000 with IRC-
Connect.
Chapter 19 Maintenance This chapter describes the required maintenance for the
STa 6000.
Chapter 20 Torque / Angle Coefficient
Calculation for MRTT-C
Extension
This chapter shows the operator how to calculate the
correction coefficients when an extension is used with
the MRTT-C.
Chapter 21 STa 6000 Factory Settings This chapter shows the STa 6000 factory settings.
Chapter 22 Appendix A EAP-TLS
security type
This chapter described how to configure the IRC-W
module for EAP-TLS security type.
Chapter 23 Troubleshooting Guide This chapter provides a guide to solve the most common
problems with the STa 6000.
Chapter 24 Abbreviations Table of abbreviations used in this user guide.
Chapter 25 Index Index used in this user guide.
To Next Page
Loading...
Need help?
General
