Atlas Copco STbench System Overview Manual

Introduction EN STbench
6
© Atlas Copco Industrial Technique AB - 9839 0879 01
Software version Change
04.03x
■
SPC dimensional parameters updated (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Cp/Cpk dimensional parameters updated (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Searching in a route updated (for more information, see "STbench with
PC Configuration Manual / STpad Configuration Manual").
■
Navigating a forced by piece route added (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Viewing the details of the inspection results updated (for more informa-
tion, see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
Calibrating generic controller updated (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Running tool inspection updated (for more information, see "STbench
with PC Configuration Manual / STpad Configuration Manual").
■
Results category (tool inspections) updated (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Picture inspection parameters added (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Instruction inspection parameters added (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Results category for Picture inspection added (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Results category for Instructions inspection added (for more information,
see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
General settings updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Verification code added (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Starting the device updated (for more information, see "STbench with
PC Configuration Manual / STpad Configuration Manual").
■
Cm/Cmk ISO parameters (Tool check) updated (for more information,
see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
SPC parameters updated (Tool check) updated (for more information,
see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
SPC rules updated (for more information, see "STbench with PC Config-
uration Manual / STpad Configuration Manual").
■
SPC, results, limits and rules updated (for more information, "STbench
with PC Configuration Manual / STpad Configuration Manual").
■
SIGOP/SCOUP integration added (for more information, see "STbench
with PC Configuration Manual / STpad Configuration Manual").
■
Power saving mode added (for more information, see "STbench Opera-
tion Manual").
■
Main panel updated (for more information, see "STbench Operation
Manual").
■
Troubleshooting updated (for more information see"STbench System
Overview Manual").

Atlas Copco STbench Specifications

General

Brand	Atlas Copco
Model	STbench
Category	Test Equipment
Language	English