STbench EN Introduction
© Atlas Copco Industrial Technique AB - 9839 0879 01
7
Software version Change
04.02x
■
General manual update (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Filtering a route added (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Results updated (for more information, see "STbench with PC Configu-
ration Manual / STpad Configuration Manual").
■
Tool inspections updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Filtering the results updated (for more information, see "STbench with
PC Configuration Manual / STpad Configuration Manual").
■
Exporting the results added (for more information, see "STbench with
PC Configuration Manual / STpad Configuration Manual").
■
Tool parameters updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Summary for JJF 1610:2017 added (for more information, see "STbench
with PC Configuration Manual / STpad Configuration Manual").
■
SPC rules updated (for more information, see "STbench with PC Config-
uration Manual / STpad Configuration Manual").
■
JJF 1610:2017 parameters added (for more information, see "STbench
with PC Configuration Manual / STpad Configuration Manual").
■
Summary for JJF 1610:2017 added (for more information, see "STbench
with PC Configuration Manual / STpad Configuration Manual").
■
General settings updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Cam-over strategy added (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Strategies parameters updated (for more information, see "STbench
with PC Configuration Manual / STpad Configuration Manual").
■
Messages displayed while running a test on the Motorized cell (for more
information, see"STbench Operation Manual").
To Next Page
Loading...
Need help?
General
