- 35 -
- Unit
This menu can be accessed to select units of
measure in either metric (°C, bar) or imperial (°F,
psi) units.
See also "Parameter list" on page 34 for selection
between metric (°C) or imperial (°F) units.
- Auto NoLoad
When "no" selected the unit will remain in unload
when not loaded for a certain time.
When "yes" selected the unit will switch to noload
when running unload for a certain time.
- ST1 Reset
- ST2 Reset
These views are the Service Timer resets. When
"Yes" is selected a customer level password will
be requested prior to approving the Service Timer
Reset.
When a service timer alarm occurs and is
acknowledged, the service timer will be reset
automatically.
- Unit Type
This view shows the model type of the
compressor.
1 = default unit type
It is possible to scroll between configuration
menu's by using the pushbuttons UP and DOWN.
Pushing the ENTER button activates the
configuration menu which is shown on the
display.
- Extra views display
This view shows the extra views available in the
controller.
- Fuel pressure
This view shows the fuel pressure and the running
hours.
See also "Parameter list" on page 34 for selection
between metric (bar) or imperial (psi) units.
- Fuel consumption
This view shows the engine fuel consumption and
the running hours.
See also "Parameter list" on page 34 for selection
between metric (L/h) or imperial (Gal/h) units.
Unit
C/bar C/bar F/psi
Auto NoLoad
No No Yes
ST1 Reset
No No Yes
Unit Type
1 1 10
Extra Views
To Next Page
Loading...