Atlas Copco XAVS 136 Dd - Page 23

23
Instruction Manual
(1) More frequently when operating in a dusty environment.
(2) Replace the element when the pressure drop exceeds 0.8 bar.
(3) Refer to the Deutz operation manual.
(4) 500 hours only valid when using PAROIL SAE 15 W 40.
(5) In case of poor fuel quality, replace fuel filter more frequently.
(6) Clean retainer when replacing element.
(7) The following part numbers can be ordered from Atlas Copco to
check on inhibitors and freezing point:
2913 0028 00: Refractometer
2913 0029 00: pH-meter
MAINTENANCE SCHEDULE
Daily Initially Normal Yearly
50 hours after initial
start-up
or every 500 hours or every 1000 hours
Service Paks
XAVS 136 Dd - XAHS 146 Dd supplied with unit 2912 4306 05 2912 4338 06
XATS 156 Dd - XA(S) 186 Dd supplied with unit 2912 4306 05 2912 4337 06
XAHS 186 Dd supplied with unit 2912 4331 05 2912 4332 06
Engine oil level Check
Compressor oil level Check
Coolant level (3) Check
Coolant (7) Analyse Analyse
Air filter vacuator valves Empty
Fuel filter water drain Drain
Air intake vacuum indicators Check
Electrolyte level and terminals of battery Check Check Check
Tyre pressure Check Check Check
Leaks in air-, oil- or fuel system Check Check Check
Coolers (Oil, Coolant, Inter-) Clean Clean
Engine minimum and maximum speeds Check Check Check
Torque of wheel nuts Check Check Check
Brake system (if installed) Check/Adjust Check/Adjust Check/Adjust
Safety valve Test
Door hinges Grease Grease
Coupling head and all its moving parts / shaft Grease Grease
Joints of height adjustment adjustable towbar Check Grease Grease
Shutdown switches Check
Pressure drop over separator element (2) Measure Replace (6)
Fan V-belts (3) Adjust Adjust
Fuel tank Clean Clean
Compressor oil Change
Compressor oil filter Replace
Air filter elements (1) Replace
Safety cartridges (1) (option) Replace
Engine oil (3) (4) Change Change
Engine oil filter (3) Replace Replace
Fuel filter (3) (5) Replace
Fuel prefilter (3) Replace Replace
Engine inlet and outlet valves (3) Adjust
PD/QD filter (option) Replace
Keep the bolts of the housing, the lifting eye, the towbar and the axle securely tightened.
Refer to section 8. ’Technical specifications’ and section 3.1.3 for the torque values.