9
2.0 SAFETY RULES
2.1 General notes
WARNING
Before performing any operation on the machine, carefully read through the entire
manual,paying particular attention to this chapter.
The machine has been designed and constructed in observance of the CE requirements taking into account normal
and reasonably foreseeable use.
The machine has been constructed for the application stated in the user manual attached hereto.
It is not permitted for any reason whatsoever to use the machine for purposes different from those for which it was
designed nor to use it in ways different from those described in this manual.
The various operations must be performed according to the criterion and the chronology described in this manual.
2.2 Symbols
Throughout this manual dangerous operations are highlighted with graphic symbols to draw the reader’s attention.
WARNING
This warning indicates possible occurrence of an event that may lead to serious
injury or extensive damage to the machine if adequate precautionary
countermeasures are not taken.
2.3 Denitions of “operator” and “specialised technician”
Any professional person who is to access the machine for operation and routine maintenance is dened as an
“operator”.
This means persons who have knowledge of the operating and maintenance procedures of the machine and
have the following qualications:
1. training that authorises operation according to the safety standards in relation to the risks deriving from the
presence of electrical power and moving devices and the risks related to manual load handling.
2. Trained to use the personal protection devices and basic rst aid training.
The employer must assign a suitable person to operate the machine in accordance with the laws in force, assessing
his or her psycho-physical health, personal education, training and experience, as well as knowledge of the standards,
requirements and provisions for accident prevention.
In addition, the operator assigned based on the above must be specically trained for use of the machine and any
accessories.
Finally, the operator must read through this manual.
To Next Page
Loading...
Need help?
General
