To Next Page

To Previous Page

MOUNTING THE ARIES 258

1. Slightly loosen horizontal and vertical fixator screws on the dove tail clamps, allowing the

clamps to slide on the rail.

2. Place the scope on dovetail mount, making certain that the mount aligns with the receptor

attachment screw groove. Adjust as necessary.

3. Tighten horizontal fixator screws.

4. Remove the Aries scope entire mounting mechanism. Tighten vertical fixator screws and

horizontal fixator screws.

5. Remount Aries 258 and tighten receptor attachment screws.

NOTE: Receptor attachment screws may need to be tightened after continues shooting.

WINDAGE AND ELEVATION

The vertical and horizontal adjustments for the Aries 258 can be achieved by turning the eleva-

tion and windage adjustment mechanisms. Each click equal .5 inch at 100 yards.

NOTE: When reaching the maximum of the rotation, do not use force.

Windage

Elevation

Screws

Questions and Answers:

Need help?

Do you have a question about the ATN Aries MK and is the answer not in the manual?

ATN Aries MK Specifications

General